Hello all!
First time poster here and also a recent graduate, so I might not even be using the proper terminology.
I'm making a series of tanks that share walls, with "built-in drainage" since it'll be 3D-printed (see attached file). What I'm trying to add is a slope from the edge of the drain at the bottom of each tank to the edge of all 4 sides of each tank. I want the "rise" of this slope to be 5mm, though this doesn't have to be exact, or I can calculate an angle, etc.
I have absolutely no clue where to start. What function do I use? My "go-to" is Round or Chamfer, but those don't give me control over what the slope is, since this will be rather gentle.
Thank you in advance!!!
Paul