Clik here to view.
Clik here to view.
Re: make spiral hexagon
Hi, a simple method would be to extrude an hexagonal surface, & wrap a line around it, & use this as a trajectory for a sweep. Not very scientific, but simple, & seems to work. Good luck....
View ArticleRearranging/inserting figures in Creo Illustrate
I am new to Creo Illustrate and I have a question regarding rearrangement/insertion of of figues in Creo Illustrate 3.When I insert a new blank figure it's always added at the end after all the...
View ArticleRe: Swept blend feater is rotated
Due cooperate with czech technical support from Aveng l discovered, that problem is in model accuracy. Change to bigger value repaired failed swept blend feater.
View ArticleClik here to view.
Re: how to develop this?
The problem with your model appears to be in the boundary blend definitions. If you flatten just one of the triangle, and place a point along a long edge, you will see the end of the sheet is no...
View ArticleRe: how to develop this?
One of the challenges was to get a sharp point at the top for the true circle. That is the reason for the high feature count. Of course, there is still the bend radius. Follow up work with the part...
View ArticleRe: Highlighting text in Arbortext Editor 6.1 F000
I might have misunderstood your question. What does "been better if PTC pulled in this simple MS Word feature" mean? I don't see how Arbortext Editor text highlighting is different from MS Word text...
View ArticleRe: how to develop this?
the half that you have flattened (flatten quilt) ..are the end edges flat?
View ArticleClik here to view.
Re: how to develop this?
I am going to assume so. I am working the boundary blend with control points. I cannot get a 4-arc circle to join completely with the 4 straight sides, but I can get 3 to work. So I have to trim the...
View ArticleRe: how to develop this?
strange when i use a plane to trim the surface and then flatten the edges are not flat.but when i cut with extrude and flatten the edges are flat.
View ArticleRe: how to develop this?
sorry sorry..my mistake... the one with control points and one boundary blend gives straight edges.the one with multiple boundary blend does not give straight edges.
View ArticleClik here to view.
Clik here to view.
Re: how to develop this?
I guess this is correct too, depending on where you want the seam. Of course, adding a fill at the other end is easy since it is a very easy to create triangle where the only variable is a value of...
View ArticleRe: how to develop this?
Yes, but the flatten quilt doesn't recognize it. Even in the new dialog, try selecting all 8 individual surface... it won't let you, even if the triangle is a separate surface all together. And then...
View Article